Re: Pye VT2 EHT problems
Thanks again John, I shall give all of this a go next weekend and see how I get on. I've been through all the resistors and there's nothing drastically high, the only incorrect thing I found in this area was C50 (47pf) which was a 15pf cap in my set. It was an original component so must have worked ok. I swapped it for a 47pf and it doesn't make any difference.
If I don't make any progress I may well take you up on your kind offer of a visit as I'm only down the road in Portsmouth, maybe you could cast an expert eye over it!
Best regards
Matt
|