Beogram 1200 with bent silencer switch
2 Attachment(s)
Thanks, in advance, for reading this post. I have a Beogram 1200 which I'm trying to get working again. While examining the innards, I noticed that the switch which silences the pickup signal seems to have been bent out of shape. Please see the image below.
Attachment 66249 It's all curved, whereas in the service manual it all seems to be straight lines and 90-degree bends. Here is a close up of my switch. Attachment 66248 Does anyone know what this switch should look like in real life? |
Re: Beogram 1200 with bent silencer switch
1 Attachment(s)
As a new forum member and not familiar enough with English technical vocabulary, I will do my best to enter this forum.
My first try is to ask you if you got adequate response? I had also a problem with this switch and was able to fix it: I have pictures to show how it should look like, but do not know yet how to display. E-mail? |
Re: Beogram 1200 with bent silencer switch
This must be some kind of record, a first timer being sorted out by another!
|
Re: Beogram 1200 with bent silencer switch
If all else fails you could bypass this switch. The fewer breaks in the singal path, the better.
|
Re: Beogram 1200 with bent silencer switch
I wouldn't worry about the supposed shape
It will have been "adjusted" so that it works (mutes the signal) |
Re: Beogram 1200 with bent silencer switch
Quit a common problem with the 1200. There are more pictures and discusion at "Beoworld" Search for Bent Switch.
John. |
Re: Beogram 1200 with bent silencer switch
Thanks guys, I did bypass the switch in the end. Job done :-)
|
All times are GMT +1. The time now is 4:02 am. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.